Viewing 4 posts - 31 through 34 (of 34 total)
1 2 3
  • Author
    Posts
  • September 17, 2006 at 5:38 pm #7710
    Shane Barker
    Member

    I guess I should have paid more attention at the show, I didn’t even notice they had a different machine. I don’t know much about the AXYZ line but it was my understanding that Fabricators Choice was the one that designed and/or fine tuned it for the Solid Surface industry. The good thing is they will still stand behind your machine. That says a lot about a company.

    Shane

    September 25, 2006 at 9:58 am #7930
    Tom M
    Member

    Matt,

    It was Ten floors of wall cladding in Avonite Frosted Glass (I have now become somewhat of an expert on how much this stuff can yellow), along with Emerald Jade chair rail and elevator surround. We figured initially about a 205 based on the sheer volume of the job. We did much better.

    If I can figure out how, I will post a mock-up pic.

    Tom

    September 25, 2006 at 9:59 am #7932
    Tom M
    Member

    That should be 20%, not “205”.

    September 25, 2006 at 10:34 am #7933
    Tom M
    Member

    Shane,

    I have to say that Fab Choice is awesome in their service. I have had two problems since I bought the 7012, and there was next day response. Outstanding!

    I am sorry to hear that FC is not selling them anymore.

  • Author
    Posts
Viewing 4 posts - 31 through 34 (of 34 total)
1 2 3
  • You must be logged in to reply to this topic.