Viewing 31 post (of 31 total)
1 2 3
  • Author
    Posts
  • September 28, 2006 at 4:40 pm #8116
    Shane Barker
    Member

    Thanks Seth,

    You are right it flexed a little too much. I only used it because I had it in stock. I have since found an Amana 46102 that is in our tool changer so I will give it a try just to finish what I have going. I have done some profiling but have not completely taken the plunge yet. Thanks for the info on jumping lines, looks like it makes sense, I am anxious to try it. We can speak on the phone if you like or feel free to email me any time. Thanks again.

    Shane

  • Author
    Posts
Viewing 31 post (of 31 total)
1 2 3
  • You must be logged in to reply to this topic.