Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Does anyone know how to get the machining time from Alphacam software without actually running the program ? Thanks in advance for any help.
Go to Utils > Add-Ins
This will bring up a bunch of add-in to enhance the functionality of AlphaCAM.
Scroll down to ‘Setup Sheets’, Check the box, and press OK.
It will install that functionality.
Click File > Set Up Sheets
You need to have Microsoft Word installed (I think but not positive). It will basically bring up a sheet with all the information about that job including the run time. It’s not exact but close.
I’m sure there is an easier way, I just don’t know it.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.