Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 30, 2009 at 12:06 pm #3607
    Todd Simoneaux
    Member

    I have had my Proliner 8.0 for awhile now and the CAD program that comes with the unit, Vector, is not very user friendly. Can any CAD program be used? Can someone recommend one?

    May 1, 2009 at 2:28 am #51723
    Patrick McGrath
    Member

    Todd,
    we use Alpha Cam successfully and find it fine for getting from Proliner to CNC.We’d be happier if the output on the CAD side was good enough to replace the drawings we do for customer approval. We currently do those on VISIO which gives a good clean readable drawing.

    I would assume that any CAD program would be fine. Drop a line to info@proliner-usa.com and I’m sure they’ll advise.

    ,

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.