Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • March 24, 2008 at 1:58 pm #2291
    AJ Moore
    Member

    Does anyone have a reliable dwg ordxf for this sink, I even contacted Blanco but what they sent would not scale properly into my dwg.

    March 24, 2008 at 2:10 pm #36909
    Andy Graves
    Keymaster

    I couldn’t find that sink listed on the Blanco website. Were you able to download the file?

    March 24, 2008 at 2:17 pm #36911
    AJ Moore
    Member

    Yes I have it down Loaded, but it will no auto scale in to my dwg, when i try to scale it by reference the O.A. across is correct but front to back is off by 3/4 inch

    March 24, 2008 at 2:22 pm #36912
    AJ Moore
    Member

    I entered a incorrect # the correct # is 513-633 ( sorry)

    March 24, 2008 at 2:49 pm #36914
    Andy Graves
    Keymaster

    If the front to back measurements are off, draw a horizontal center line and then offset 3/8″ top and bottom. Then cut this section out and make a test. I have done this in the past with success.

    The file I sent you was scaled down equal all the way around. hopefully that fixed the problem.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.