Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 18, 2012 at 12:05 pm #5630
    Brady Hudson
    Member

    I’ve got a job asking for us to cut a 5/8″ wide by 1/4″ deep rabbet to accomodate a window track.  How do you guys typically do this?

    Thanks,

    Brady

    June 19, 2012 at 7:05 pm #72392
    Steve Mehan
    Member

    Do you have to make the top one piece. If i could get around it i would two piece it at the track.

    June 20, 2012 at 12:23 am #72394
    Chris Yaughn
    Member

    How long are the cuts?

    If they are open on the ends, just do it with the bridge saw, stepping it over a little each time.   

    If they are trapped, you could do it on the CNC with a new 1/2” fingerbit set to the right depth. You might need to clean up the ends by hand with a dremmel or something.

    June 22, 2012 at 12:41 pm #72401
    Brady Hudson
    Member

    Thank you gentlemen!

    They wanted it ran all the way out on one and captured on another.  I think I got it figured out now. 

    thanks again,

    Brady

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.