[Andy Graves]

Anyone know of a trim bit with the bearing on the bottom that cuts perfectly flat leaving no material.

The bits we get always leave a little material that is supposed to be trimmed.

We end up having to sand or plane the surface, typically an edge, to make it flat.

[Dani Homrich]

Andy

Switch to insert tooling it is the only to go If cutter isn’t flush you can shim the back edge of the cutter with a small strip of paper.

I use the Amana RC-1004 it has 1 1/8″ cutter

[Andy Graves]

That is awesome. We have an insert tooling, I will try the paper shim idea.

Thanks for the help, great tip.

[Author]

Posts